Filter
Top Products
14
POSITIONING THE RADIO-CONTROLLED CLOCK:
There are two possible ways to mount the radio-controlled clock:
• use of the foldout table stand, or
• wall mounting
FOLDOUT TABLE STAND
The foldout table stand leg is located on the backside. Pull the stand out from
the bottom center edge of the radio-controlled clock, below the battery
compartment. Once the foldout table stand is extended, place the radio-
controlled clock in an appropriate location.
WALL MOUNTING
1) Using a straightedge, horizontally space at 2-3/4 of an inch (70 mm)
three screw positions on a wall.
2) Install three mounting screws (not included) into a wall within
transmission range—leaving approximately 3/16 of an inch (5mm)
extended from the wall.
3) Place the radio-controlled clock onto the screws, using the hanging
holes on the backside. Gently pull the radio-controlled clock down to
lock the screws into place.
Note:
Always ensure that the radio-controlled clock locks onto the screws before
releasing.