Filter
Top Products
Setup Steps
I) Install an internal hard disk drive.
1. Make certain the power and USB 2.0 cables are disconnected from the LaCie box.
2. Turn the box over so that the rubber feet are pointing
up. Please note the two plastic bands for prying the
bottom plate from the top shell.
3. Open the casing by taking one plastic band in each
hand, between the thumb and index finger, and pull gently
until the bottom plate and the top shell have come apart.
4. Turn the enclosure
over, onto its rubber feet.
Remove the top shell and
safely place it within reach.
5. Gently slide the 3.5” SATA drive, label facing
up, onto the bottom plate until the SATA connector
plugs into the box’s internal SATA port. You will
feel the connection rather than hearing an audible
signification.
6. Secure the disk drive in the casing by inserting the four screws
(included).