Filter
Top Products
1200 Series User’s Manual
8
Changing the Motor
Figure 6
1. Unplug cord from wall outlet.
2. Remove type section from main frame (see “Replacing
the Type Section”).
3. Figure 6 shows a close-up of cam block terminal.
4. Disconnect Motor Wire Leads – 6.1 by turning each
Screw – 6.2 one-quarter of a turn counterclockwise.
5. Remove the Motor Clutch – 6.3 from its shaft. The
shaft has LEFT HAND threads – remove clutch by
turning clockwise
.
6. Hold Motor Bracket – 6.4 and loosen Motor Mounting
Screws – 6.5. Remove and retain screws and bracket
from old motor.
7. Install motor clutch on new motor. Turn
counterclockwise to tighten. DO NOT OVERTIGHTEN
OR BEND – YOU MAY DAMAGE INTERNAL MOTOR
GEARS.
8. Install new motor.
9. Plug cord back in wall outlet, and reset the time.