28
ENGLISH
Follow the steps below to connect an external time signal device.
6.
CONNECTING EXTERNAL TIME SIGNAL
3 Insert wires into Terminals while
pushing upper part of Terminal Block
with screwdriver, then tighten both
screws of cable clamp.
4 Fold down Cover Plate and secure
with screw. Route Power and Bell
wires through Channel in base of clock.
1 Unscrew the screw fixed on the
bottom of the unit to remove the
cover plate.
2 Feed wires through clamp. Do not
tighten clamp screws.
Connection Specifications for External
Contact
s#ONTACTOUTPUT/NECIRCUITDRYCONTACT
s#ONTACTCAPACITY!6$#!6!#
Screw Cover Plate
"OTTOM6IEW
#LOCK2ELAY
!MPS-AX
6!#
Maximum of 8 bells/horns (typical)
8
Channel