Filter
Top Products
Page 12
PROGRAMMING EVENTS
(Bell Ringer)
NOTE: Dip Switch 4 must be set to ON (see page 8)
With “SELECT FUNCTION” displayed, press the PRGM
EVENTS key. The display should read “SIGNAL 12:00 AM” “ON
DAYS:” Use the FAST FWD and SLOW FWD keys to advance
the displayed time to the desired event time. Once the event
time is reached, press the day of the week keys (Sun, Mon, Tue,
etc.) to indicate on which day(s) the bells should ring. Pressing a
key once will display the day of the week and pressing it again
will remove it. Once you have chosen the day(s) for the event,
use the forward keys to advance the time to the next event and
enter the days. Continue in this fashion until all events are
programmed . Press RUN to lock the keypad and return to the
normal display.
While in the Program Events function, the PRGM REVIEW and
ERASE EVENT keys can be used to scan and erase events,
respectively. To scan programmed events, simply press the
PRGM REVIEW key. The next event in memory will be located
and displayed. Pressing the key repeatedly will scan through all
events sequentially. To erase an event, locate the event and
press the ERASE EVENT key.
PRGM REVIEW may also be used when the keypad is locked.
Pressing the key will display the next scheduled event. Press
the key repeatedly to scan all programmed events. The normal
display will return after 5 seconds or when the RUN key is
pressed.
PROGRAMMING SIGNAL LENGTH
(Bell Ringer)
The signal length defaults to 5 seconds. To change this value,
unlock the keypad and press the SIGNAL LENGTH key. The
current signal length will be displayed. Use the FAST FWD and
SLOW FWD keys to change the setting. Values from 1 to 99
seconds are allowed. Press RUN to return to the normal display.
To review the signal length without unlocking the keypad, simply
press the SIGNAL LENGTH key. The normal display will return
after 5 seconds or when the RUN key is pressed.