Lava Computer DSerial-PCI/LP Card Computer Hardware User Manual


 
DOS and Windows 3.x Installation
1. With the power turned off,insert the DSerial-PCI/LP card into any
free PCI slot in your PC.Turn your PC on.
2. Place the DSerial-PCI installation diskette into your floppy drive.
In the Win3.11\16550 subdirectory of this diskette you will find a file
called“Lavaconf.exe”.Copy this file to your hard drive and run it.
3. When run,Lavaconf.exe will display two I/O addresses and one IRQ.
These correspond to the addresses and IRQ chosen by your PC when
configuring the DSerial-PCI .Make a note of them.
4. If you are using Windows 3.x,start Windows and go to Control Panel
| Ports.Choose Com 3 for Port 1 and Com 4 for Port 2 on the DSerial-
PCI .Click the Advanced button and enter the I/O address and IRQ
for each port as reported by Lavaconf.exe.Reboot your PC for these
changes to take effect.
Note:DOS and Windows 3.X support a maximum
of four Com Ports in a PC.
/LP
/LP
/LP