Filter
Top Products
6. Slide the new hard disk drive into the hard disk drive bay and align the screw
holes in the new hard disk drive with the corresponding holes in the drive bay.
Then, install the four screws to secure the new hard disk drive in place.
7. Connect one end of the signal cable to the rear of the new hard disk drive and
the other end to an available SATA connector on the system board. See
“Locating parts on the system board” on page 11. Then, locate an available
five-wire power connector and connect it to the rear of the new hard disk
drive.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation or replacement, go to “Completing the parts
replacement” on page 37.
Figure 26. Installing the hard disk drive
Figure 27. Connecting a SATA hard disk drive
Chapter 2. Installing or replacing hardware 33