Lenovo 0829T2U Personal Computer User Manual


 
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 14.
3. Locate the primary hard disk drive. See “Locating internal drives” on page 11.
Note: There is also a secondary hard disk drive bay for you to purchase and
install a secondary hard disk drive by yourself. If you want to install a
secondary hard disk drive, use the same way of installing the primary
hard disk drive.
4. Disconnect the signal cable and the power cable from the rear of the hard disk
drive.
5. Remove the four screws that secure the hard disk drive. Then, slide the hard
disk drive out of the chassis.
Figure 25. Removing the hard disk drive
32 User Guide