Filter
Top Products
2. Remove the computer cover. See “Removing the computer cover” on page 32.
3. Locate the battery. See “Locating parts on the system board” on page 11.
4. Remove the old battery.
Figure 19. Removing the old battery
5. Install a new battery.
Figure 20. Installing a new battery
6. Reinstall the computer cover and connect the cables. See “Completing the parts replacement” on
page 70.
Note: When the computer is turned on for the rst time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
7. Turn on the computer and all attached devices.
8. Use the Setup Utility program to set the date, time, and any passwords. See Chapter 7 “Using the Setup
Utility program” on page 81.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 70.
Installing the solid state drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
on page v
.
This section provides instructions on how to install the 2.5-inch solid state drive.
To install the solid state drive, do the following:
40 ThinkCentre User Guide