Lenovo 2011 Laptop User Manual


 
Do not write or stick paper on the disc.
Do not scratch or mark the disc.
Do not place or store the disc in direct sunlight.
Do not use benzene, thinners, or other cleaners to clean the disc.
Do not drop or bend the disc.
Do not insert damaged discs into the drive. Warped, scratched, or dirty discs can damage the drive.
Playing a CD or DVD
If your computer comes with a DVD drive, you can listen to audio CDs or watch DVD movies. To play a
CD or DVD, do the following:
1. Press the Eject/Load button on the DVD drive to open the tray.
2. With the tray fully extended, insert the CD or DVD into the tray. Some DVD drives have a snap hub in the
center of the tray. If your drive has a snap hub, support the tray with one hand and then push on the
center of the CD or DVD until it snaps into place.
3. Press the Eject/Load button again or gently push the tray forward to close the tray. The CD or DVD
player program starts automatically. For additional information, refer to the CD or DVD player program
help system.
To remove a CD or DVD from the DVD drive, do the following:
1. With the computer on, press the Eject/Load button. When the tray slides out automatically, carefully
remove the disc.
2. Close the tray by pressing the Eject/Load button or by gently pushing the tray forward.
Note: If the tray does not slide out of the drive when you press the Eject/Load button, insert a straightened
paper clip into the emergency-eject hole located on the front of the DVD drive. Be sure the drive is powered
off when using the emergency eject. Use the Eject/Load button instead of the emergency eject except
in an emergency.
Recording a CD or DVD
If your computer comes with a recordable DVD drive, you can use the drive to record CDs or DVDs.
To record a CD or DVD, do one of the following:
On the Windows 7 operating system, you have either the Corel DVD MovieFactory Lenovo Edition program
or the Power2Go program installed on your computer.
To run the Corel DVD MovieFactory Lenovo Edition program, click Start All Programs Corel
DVD MovieFactory Lenovo Edition Corel DVD MovieFactory Lenovo Edition. Follow the
instructions on the screen.
To run the Power2Go program, click Start All Programs PowerDVD Create Power2Go.
Follow the instructions on the screen.
On the Windows 8 operating system, run the Power2Go program by doing the following:
1. Move the cursor to the top-right or bottom-right corner of the screen to display the charms. Then
click Search and type Power2Go.
2. Click Power2Go in the left panel to open the program.
3. Follow the instructions on the screen.
You also can use Windows Media
®
Player to record CDs and data DVDs. For more information, see “Help
and Support” on page 119.
Chapter 2. Using your computer 21