Filter
Top Products
Setting up your monitor
This section provides information to help you set up your monitor.
Connecting and turning on your monitor
Note: Be sure to read the Safety Information located in the Monitor Safety,
Troubleshooting, and Warranty Guide before carrying out this procedure.
1. Power off your computer and all attached devices, and unplug the computer power
cord.
2.
Connect the analog signal cable to the D-SUB connector of the monitor and the
other end on the back of the computer.
Note: One end of the signal cable is already pre-attached to your monitor.
1-4
LT1952p Wide Flat Panel Monitor User’s Guide