Filter
Top Products
Removing a 2.5-inch hot-swap hard disk drive
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each drive bay.
To remove a 2.5-inch hot-swap hard disk drive, do the following:
1. Read the safety information (see “Safety” on page vii and “Installation
guidelines” on page 37).
Attention: Static electricity that is released to internal server components
when server is powered on might cause the server to halt, which might result in
the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
2. Unlock the side cover.
3. Open the bezel. Place your finger on the pull-point area on the left side of the
bezel door and rotate it away from the server.
4. Press the release latch at the top of the drive to release the drive handle.
5. Rotate the handle on the drive upward to the open position.
6. Pull the hot-swap drive out of the bay approximately 25 mm (1 inch). Wait
approximately 45 seconds while the drive spins down before you remove the
drive completely from the bay.
70 ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide