Lenovo 3798 Computer Hardware User Manual


 
4. Remove the PCI riser-card assembly that contains the adapter (see “Removing
a PCI riser-card assembly” on page 167).
v If you are removing an adapter from PCI expansion slot 1 or 2, remove PCI
riser-card assembly 1.
v If you are removing an adapter from PCI expansion slot 3 or 4, remove PCI
riser-card assembly 2.
5. Disconnect any cables from the adapter (make note of the cable routing, in case
you reinstall the adapter later).
6. Carefully grasp the adapter by its top edge or upper corners, and pull the
adapter from the PCI expansion slot.
7. If the adapter is a full-length adapter in the upper expansion slot of the PCI
riser-card assembly and you do not intend to replace it with another full-length
adapter, remove the full-length-adapter bracket and store it on the underside of
the top of the PCI riser-card assembly.
8. If you are instructed to return the adapter, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Installing a PCI adapter in a PCI riser-card assembly
To ensure that a ServeRAID-10i, ServeRAID-10is, or ServeRAID-10M adapter
works correctly in your server, make sure that the adapter firmware is at the latest
level.
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest
level of code is supported for the cluster solution before you update the
code.
Some high end video adapters are supported by your server. See
http://www.lenovo.com/thinkserver for more information.
Notes:
1. If you are installing a video adapter in your server, do not set the maximum
digital video resolution above 1600 x 1200 at 60 Hz for an LCD monitor. This is
the highest resolution supported for any video adapter in this server.
2. Any high-definition video-out connector or stereo connector on the video adapter
is not supported.
These instructions apply to PCI adapters such as video graphics adapters and
network adapters. To install a SAS controller, go to “Installing a SAS controller on
the SAS riser card” on page 204.
Chapter 6. Removing and installing FRUs 171