Filter
Top Products
Diagnostic Error Code FRU/Action
086-197-XXX Mouse Port interface test warning
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility” on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
086-198-XXX Mouse Port interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility” on page 43
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Go to “Undetermined problems” on page 69
086-199-XXX Mouse Port interface test failed, cause
unknown
1. See “Undetermined problems” on page 69
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Replace component under function test
089-000-XXX Microprocessor Test Passed No action
089-XXX-XXX Microprocessor failure
1. Microprocessor(s)
2. System board
089-195-XXX Microprocessor Test aborted by user
Information only Re-start the test, if necessary
089-196-XXX Microprocessor test halt, error threshold
exceeded
1. Press F3 to review the log le
2. Re-start the test to reset the log le
089-197-XXX Microprocessor test warning 1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility” on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
089-198-XXX Microprocessor test aborted
1. Flash the system. See “Updating (ashing) BIOS
from a disc” on page 560
2. Go to “Undetermined problems” on page 69
089-199-XXX Microprocessor test failed, cause unknown
1. See “Undetermined problems” on page 69
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Replace component under function test
170-000-XXX Voltage Sensor(s) Test Passed
No action
170-0XX-XXX Voltage Sensor(s) failure
1. Flash system
2. System board
170-195-XXX Voltage Sensor(s) Test aborted by user
Information only Re-start the test, if necessary
170-196-XXX Voltage Sensor(s) test halt, error threshold
exceeded
1. Press F3 to review the log le
2. Re-start the test to reset the log le
62 ThinkCentre Hardware Maintenance Manual