Filter
Top Products
Diagnostic Error Code FRU/Action
011-001-XXX Serial port Presence
1. Remove external serial device, if present
2. Run setup, enable port
3. System board
011-002-XXX 011-003-XXX Serial port Timeout/Parity
error
System board
011-013-XXX 011-014-XXX Serial port Control
Signal/Loopback test failure
System board
011-015-XXX Serial port External Loopback failure
1. Wrap plug
2. System board
011-027-XXX Serial port Conguration/Setup error 1. Run Setup, enable port
2. Flash the system. See “Updating (ashing) BIOS
from a disc” on page 560
3. System board
011-03X-XXX 011-04X-XXX Serial port failure System board
011-195-XXX Serial port Test aborted by user
Information only Re-start the test, if necessary
011-196-XXX Serial port test halt, error threshold
exceeded
1. Press F3 to review the log le
2. Re-start the test to reset the log le
011-197-XXX Serial port test warning
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility” on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
011-198-XXX Serial port test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility” on page 43
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Go to “Undetermined problems” on page 69
011-199-XXX Serial port test failed, cause unknown 1. Go to “Undetermined problems” on page 69
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 560
3. Replace component under function test
011-2XX-XXX Serial port signal failure
1. External serial device
2. System board
014-000-XXX Parallel port Interface Test Passed
No action
014-001-XXX Parallel port Presence 1. Remove external parallel device, if present
2. Run setup, enable port
3. System board
014-002-XXX 014-003-XXX Parallel port Timeout/Parity
error
System board
014-013-XXX 014-014-XXX Parallel port Control
Signal/Loopback test failure
System board
54 ThinkCentre Hardware Maintenance Manual