Filter
Top Products
Diagnostic error code FRU/Action
005-016-XXX Video Simple Pattern test failure
1. Video Ram
2. Video card, if installed
3. System board
005-024-XXX Video Addressing test failure
1. Video card, if installed
2. System board
005-025-XXX Video Checksum Value error
1. Video card, if installed
2. System board
005-027-XXX Video Conguration/Setup error 1. Run Setup
2. Video drivers update
3. Video card, if installed
4. System board
005-031-XXX Video Device Cable failure
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
005-032-XXX Video Device Controller failure
1. Video card, if installed
2. System board
005-036-XXX Video Register error 1. Video card, if installed
2. System board
005-038-XXX System BIOS extension failure
1. Video card, if installed
2. System board
005-040-XXX Video IRQ failure
1. Video card, if installed
2. System board
005-195-XXX Video Test aborted by user
Information only Re-start the test, if necessary
005-196-XXX Video test halt, error threshold exceeded 1. Press F3 to review the log le
2. Re-start the test to reset the log le
005-197-XXX Video test warning 1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 39
2. Re-run test
3. Replace the component called out in warning
statement
4. Replace the component under test
005-198-XXX Video test aborted 1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 39
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 203
3. Go to “Undetermined problems” on page 65
005-199-XXX Video test failed, cause unknown
1. Go to “Undetermined problems” on page 65
2. Flash the system and re-test. See “Updating
(ashing) BIOS from a disc” on page 203
3. Replace component under function test
48 ThinkCentre Hardware Maintenance Manual