Filter
Top Products
Chapter 4. Completing the parts replacement
After replacing the parts, you need to close the cover and reconnect cables,
including telephone lines and power cords. Also, depending on the part that was
replaced, you might need to confirm the updated information in the Setup Utility
program. Refer to ″Using the Setup Utility″ in the User Guide for this product.
To complete the parts replacement:
1. Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer. See “Locating components” on
page 8 for the location of various components.
2. Position the computer cover on the chassis so that the rail guides on the bottom
of the computer cover engage the rails. Then, push the computer cover closed
until it snaps into position.
3. If the cover is secured with thumbscrews, install them.
4. If a cover lock is installed, lock the cover.
5. Reconnect the external cables and power cords to the computer. See “Locating
connectors on the rear of your computer” on page 6.
6. To update your configuration, see ″Using the Setup Utility″ in your User Guide.
Figure 37. Replacing the computer cover
© Lenovo 2005, 2007. Portions © IBM Corp. 2005. 43