Filter
Top Products
This section provides instructions on how to replace a memory module.
Note: Your computer has support for two memory modules.
1. Remove the computer cover. See “Removing the cover” on page 12.
Note:
For this procedure, it helps to lay the computer on its side.
2. Locate the memory connectors. See “Identifying parts on the system board” on
page 9.
3. Remove the memory module being replaced by opening the retaining clips as
shown.
4. Position the replacement memory module over the memory connector. Make
sure the notch 1 on the memory module aligns correctly with the connector
key 2 on the system board. Push the memory module straight down into the
connector until the retaining clips close.
5. Go to Chapter 4, “Completing the parts replacement,” on page 47.
Figure 32. Removing the memory module
Figure 33. Installing the memory module
Chapter 3. Installing options and replacing hardware 37