Filter
Top Products
The following illustration shows the components of server models with 3.5-inch hot-swap hard disk drives.
ID
Mem
CPU
PSU
Figure 11. Components of server models with 3.5-inch hot-swap hard disk drives
1 System fans
11 Right rack handle
2 Twenty memory slots (installed memory modules
vary by model)
12 Hard disk drive bay 3
3 PCI Express card 13 Optical drive bay (with an optical drive installed in some
models)
4 Cooling shroud
14 Hard disk drive bay 2
5 Riser card assembly 1
15 Pull-out information card
6 PCI Express card
16 Hard disk drive bay 1
7 Riser card assembly 2 17 Intelligent Diagnostics Module
8 Power supply 18 Hard disk drive bay 0
9 Heat sinks (2)
19 Front panel
10 Hot-swap hard disk drive backplane
20 Left rack handle
• For more information about 13 , 17 , and 19 , see “Front view of the server” on page 14.
• There is a 3.5-inch hot-swap hard disk drive or a dummy hard disk drive tray installed in each hard
disk drive bay (
12 , 14 , 16 , and 18 ).
Note: The number of the installed hard disk drives varies by model. For the vacant drive bay, there is a
dummy hard disk drive tray to cover the place.
• For information about the riser card assemblies, see “Replacing the riser card assembly 1” on page 128.
• Depending on the model, your server might come with one or two hot-swap redundant power supplies.
Chapter 3. Product overview 23