Filter
Top Products
Internal drives
Internal drives are devices that your server uses to read and store data. You can
add drives to your server to increase storage capacity and enable your server to
read other types of media. Internal drives are installed in bays. In this manual, the
bays are referred to as bay 1, bay 2, and so on.
Figure 5 shows the locations of the drive bays.
The following list describes the type and size of the drive that you can install in
each bay:
1 Bay 1 - Maximum height: 43.0 mm (1.7 inches) Optical drive
2 Bay 2 - Maximum height: 43.0 mm (1.7 inches) Optical drive
3 Bay 3 - Maximum height: 25.8 mm (1.0 inch) 3.5-inch secondary SATA hard disk
drive
4 Bay 4 - Maximum height: 25.8 mm (1.0 inch) 3.5-inch primary SATA hard disk drive
Figure 5. Drive bay locations
16 Installation and User Guide