Filter
Top Products
39
Chapter 2. Using Your Computer
Note:
If you set passwords through the BIOS Setup Utility and put your computer into sleep
mode by pressing Fn + F1, the following describes the behavior of the computer when
you bring it out of sleep mode:
You are prompted to enter the Windows log-on password rather than the User
password to resume operation.
If an HDD password is assigned to any hard disk drive, the hard disk drive is
unlocked automatically when you resume operation.
To set a Supervisor Password:
Only a system administrator will be able to perform this procedure.
1 Turn on your computer. Press F2, while the initial screen is displayed. The BIOS
Setup Utility screen opens.
2 Select Security, using the cursor directional keys.
3 Select Set Supervisor Password, and press the Enter key. The Set Supervisor
Password window opens.
4 Choose your Supervisor password, which can be from one to eight alphanumeric
characters in any combination. Type it in the Enter New Password field.
5 Press the Enter key once to move to the Confirm New Password field. Retype the
password you just entered to verify it.
6 Commit your password to memory, and press the Enter key.
7 Press F10 to exit.
8 Select OK in the Setup Confirmation window.
Changing or Removing the Supervisor Password
To change the password, do the following:
1 Select Set Supervisor Password, and press the Enter key. The Set Supervisor
Password window opens.
2 Choose your Supervisor password, which can be from one to eight alphanumeric
characters in any combination. Select Enter Current Password and type in the
correct password. Then press Enter key once to move to Enter New Password field,
type a new supervisor password in.