Filter
Top Products
- 15 -
* Auto-Switch Function:
When Auto-Switch mode is ON:
When you enable the AutoSwitch mode will cause KVM-0407 to switch the HUB
with the host together when you switch the host, that means host and HUB will
switch together, it could be by hotkey, push button. This is convenient for you to
let the USB device always follow the host.
There are two ways to turn the HUB Auto-Switch mode ON :
A). By hot key [Scroll+Scroll][H] : please be reference the hotkey table in page
14.
B). Press any host push button continually for 2 seconds when the Auto-Switch
mode is OFF. ( The Auto-Switch LED will be ON ).
When Auto-Switch mode is OFF:
You must switch the hub to the new target host by hotkey.
There are two ways to turn the HUB Auto-Switch mode OFF :
A). By hot key [Scroll+Scroll][H] : please reference the hotkey table in page 14.
B). Press any host push button continually for 2 seconds when the Auto-Switch
mode in ON. ( The AutoSwitch LED will be OFF)..
* Auto-Scan Function:
When you press the Auto-Scan button, KVM-0407 switches cycles through all the
ports and displays them on the monitor. Each port is displayed for 5,10,15,20
seconds before switching to the next. You can press the normal numeric key
1,2,3,4 to adjust the interval time(Please reference the hotkey table in page 14). If
you press the Auto-Scan button again, the monitor screen will jump back to the
port that it was started.
Note:
The mouse and keyboard will have no effect in this mode. This is necessary to
prevent errors such as erratic movement and wrong characters to display when
using the mouse or keyboard in accident.