Filter
Top Products
LevelOne Broadband Router User Guide
FBR-1402TX / FBR-1403TX Rear Panel
Figure 4: FBR-1402TX / FBR-1403TX Rear Panel
Printer Port
(FBR-1403TX only)
Standard parallel printer port. If you wish to share a printer,
connect it here.
Reset Button
This button has three (3) functions:
• Reboot. When pressed and released, the LevelOne Broad-
band Router will reboot (restart).
• Diagnostic print-out. If held down for 3 seconds, a diag-
nostic print-out will be sent to the attached printer.
• Ensure the printer is ready.
• Both Print LEDs will flash simultaneously during the
diagnostic printing.
• Clear All Data. This button can also be used to clear ALL
data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the
RED LED has flashed TWICE.
4. Release the Reset Button. The LevelOne Broadband Router
is now using the factory default values.
WAN port
(10/100BaseT)
Connect the DSL or Cable Modem here. If your modem came
with a cable, use the supplied cable. Otherwise, use a standard
LAN cable.
10/100BaseT
LAN connections
Use standard LAN cables (RJ45 connectors) to connect your PCs
to these ports.
Uplink Button
This button allows LAN port 1 to be used as an Uplink port for
connecting directly to another hub.
• When depressed (in), then the "LAN 1" port becomes an
"Uplink" port, and must be connected to a normal port on
another Hub.
• If this button is extended (out), then the "LAN 1" port acts as
a normal LAN port.
Power input
Connect the supplied power adapter here.
6