Filter
Top Products
16
E. Troubleshooting
I. Link LED does not lit after cable is connected to the port.
Ø Verify that the other end of the cable is connected to a
device that is powered on and on-line.
Ø For TP cable connection to another Switch or Hub, verify
that only one end of the cable is connected to a
“Crossover” port.
II. 100BASE-TX port Link LED is lit, Collision LED is blinking, but
traffic is irregular.
Ø Check that the attached device is not set to dedicated
Full-Duplex. (Some devices use a physical or software
switch to change Duplex modes. Auto-Negotiation may
not recognize this type of Full-Duplex setting).