Filter
Top Products
26
Speed/Disable:
This setting has six modes—100M Full, 100M Half, 10M Full,
10M Half, Auto and Disable—for speed or port disable
selections.
Flow Control:
This setting determines whether or not the Switch will be
handling flow control. Set FlowCtrl to Enable for avoiding data
transfer overflow. Or it sets to Disable; there is either no flow
control or other hardware/software management.
When the 10/100M port is set to full duplex mode, then the
flow control will automatically set to disable; and if the 10/100M
port is set to half duplex mode, the flow control will
automatically set to enable.
Bandwidth Control Ingress/Egress rate:
This Switch support the Port Bandwidth Rate Control, and will
work only on the auto mode.
VLAN Settings (Virtual Local Area Network)
A VLAN is a collection of switch ports that make up a single
broadcast domain. You can configure a VLAN for a single
switch, or for multiple switches. When you create a VLAN, you
can control traffic flow and ease the administration of moves,
adds, and changes on the network, by eliminating the need to
change physical cabling.
On VLAN settings, there are two main settings, VID Table
Setting and Port VLAN Setting.