![](http://pdfasset.owneriq.net/e/d2/ed24612a-bdbf-4c36-a5dc-e04c6143570d/ed24612a-bdbf-4c36-a5dc-e04c6143570d-bge.png)
10
100Base-FX Module Installation
The installation procedure for each module is the same.
Additional information about each module is provided below.
To install any of the modules: (Includes SC or ST type
connectors)
1. Locate the module slot in the switch’s rear panel.
2. Using a screwdriver, undo the two screws and remove
the dust cover on the module slot.
3. Holding the module component-side up and connector-
side in, gently slide the module along the guides and seat
it in the internal connector.
4. Using a screwdriver, replace the two screws and tighten
until snug.