Filter
Top Products
Connect <x>bps
The fax is connected. Wait for the message to clear.
Note: <x> is the baud rate per second.
Disk corrupted
The printer attempted a hard disk recovery on a corrupted hard disk, and the hard disk cannot be repaired. The hard
disk must be reformatted.
Touch Reformat disk to reformat the hard disk and clear the message.
Note: Reformatting the disk deletes all the files currently stored on the disk.
Disk Full - Scan Job Canceled
The scan job canceled or stopped due to insufficient printer hard disk space.
Touch Continue to clear the message.
Fax failed
The fax failed to be sent. Wait for the message to clear.
Fax memory full
There is not enough memory to send the fax job.
Touch Continue to clear the message.
Fax partition inoperative. Contact system administrator.
The fax partition appears to be corrupted. Try one or more of the following:
• Touch Continue to clear the message.
• Turn the printer off and then back on to reset the printer. If the message appears again, then contact your system
support person.
Fax server 'To Format' not set up. Contact system administrator.
The printer is in Fax Server mode, but the Fax Server setup has not been completed.
Try one or more of the following:
• Touch Continue to clear the message.
• Complete the Fax Server setup. If the message appears again, contact your system support person.
Fax Station Name not set up
The Fax Station Name has not been entered. Sending and receiving faxes is disabled until fax is configured properly.
Try one or more of the following:
• Touch Continue to clear the message.
• Complete the Analog Fax Setup. If the message appears again, contact your system support person.
Troubleshooting
254