Filter
Top Products
14
AppleTalk
1 Make sure the AppleTalk protocol is turned on (activated) in the print
server. To find out, print a network setup page and look under AppleTalk.
2 Make sure the status of the MarkNet print server is “connected”. To find
out, look on the network setup page for Status.
3 Do you see the printer in the Chooser? If not, restart the Macintosh
workstation and look again.
Be aware that if you’re on a
non-routed network, you can
only see the printer if your
workstation connection
(LocalTalk, Ethernet or
Token-Ring) matches the
connection on the printer. For
example, if the Macintosh
workstation is on LocalTalk,
you cannot see a printer on
Ethernet unless there is a
router on the network.
4 If you still don’t see the printer in the Chooser, make sure AppleTalk is
active on the workstation (look in the AppleTalk control panel).
5 If the job prints but the print quality is poor, refer to the printing tips
provided on the CD. These tips can save you a lot of time. To download the
document to your workstation, launch the CD, click Lexmark Installer,
select Documentation, and then click Install. Look in the Lexmark Extras
folder for the document titled Optimize Lexmark Printer Output.
6 If you are still having trouble, contact Lexmark for help. See “Lexmark
customer support” on page 15.
Other network environments
For troubleshooting information about other network environments, look on
the Drivers, MarkVision and Utilities CD. Click View Documentation and look
for the MarkNet link.