Filter
Top Products
272
Understanding the printer messages
Restore Held Jobs. Go/
Stop?
Someone reset the printer or turned it
on, and the printer detects Print and
Hold jobs stored on the hard disk.
• Press Go. All Print and Hold jobs
on the hard disk are restored to
printer memory.
• Press Return or Stop. No Print
and Hold jobs are restored to
printer memory. The printer
returns to the Ready state.
See also: Using the Print and
Hold function
Restoring Factory Defaults The printer is restoring the factory
default printer settings. When factory
default settings are restored:
• All downloaded resources (fonts,
macros, symbol sets) in the printer
memory are deleted.
• All menu settings return to the
factory default setting except:
– The Display Language setting in
the Setup Menu.
– All settings in the Parallel Menu,
Serial Menu, Network Menu,
USB Menu, and Fax Menu.
Wait for the message to clear.
See also: Restoring factory
default settings
Restoring Held Job xxx/yyy The printer is restoring held jobs from
the hard disk.
Note: xxx represents the number of
the job being restored. yyy represents
the total number of jobs to be restored.
• Wait for the message to clear.
• Select the Abort Restore menu
item in the Job Menu.
See also: Accessing held jobs
from the operator panel; Abort
Restore
Restoring Held Jobs The printer is restoring held jobs from
the hard disk.
Wait for the message to clear.
See also: Accessing held jobs
from the operator panel; Abort
Restore
Serial <x> A serial interface is the active
communication link.
Staples Empty The stapler is out of staples, or the
stapler is not installed.
If necessary, install a new staple
cartridge. Reinsert the stapler into
the finisher.
Staples Low The stapler has only a few staples
remaining.
• Press Go to continue printing.
• Install a new staple cartridge to
clear the message.
Std Bin Full The standard bin is full. Remove the stack of paper in the
bin to clear the message.
Message What this message means What you can do