Filter
Top Products
Installing and Composition
16
*Do not disconnect the power cord while the suction/discharge fan in operation. If the power cord is disconnected during
the suction/ discharge fan in operation, it may takes longer to activate the lamp after turning on the power and the lifespan
of the lamp may be shortened.
Turning on the Projector
Turning off the Projector
1.Connect power cord correctly.
2. Remove the lens cap. If it is left on, it could become deformed due to the heat produced by the
projection lamp.
3.Press the POWER button on the remote control or back cover.
●
An image will appear after the operation deco LED turns (Blue (flashing)).
●
Press the INPUT button on the remote control or the INPUT button on the control panel to select the input signal you want.
1.Press the POWER button on the back cover or remote control.
2.Press the POWER button on the back cover or remote control again to turn off the power.
3.If the operation indicator is flashing orange, in other words the fan is working (60 seconds), do not
disconnect the projector. When the indicator terns red, you may remove the power cord.
●If the operation indicator LED is orange and blinking, the power button on the back cover or on the remote control will not
operate.
Please press Power key again.
Power off?