Filter
Top Products
17
RACKMOUNT BATTERY REPLACEMENT
CAUTION- A battery can present a risk of electrical shock and high short circuit
current. The following precautions should be observed before replacing the batteries:
• Turn off and disconnect the UPS from utility power prior to opening the battery
replacement door.
• Remove rings, watches, and other metal objects.
• Use a Phillips (cross head) screwdriver with insulated grips.
• Do not lay tools or other metal objects on top of the batteries.
• If the battery replacement kit is damaged in any way or shows signs of leakage,
contact your dealer immediately.
• Do not dispose of batteries in a fire, the batteries may explode.
If you feel unqualified to replace the battery, do not open the battery door. Call
Liebert Technical Support (LTS). World Wide Technical Support numbers are located
at the end of this section.
1. Using a Phillips (cross head) screwdriver loosen the (4) screws around the
battery door as in Figure 1. Carefully remove the battery door by pulling it
forward. Lay the battery door and screws aside for reassembly.
2. Again using a Phillips (cross head) screwdriver loosen the (4) screws holding
the battery retaining plate as in Figure 2. Carefully remove the battery
retaining plate by pulling it forward. Lay the battery retaining plate and screws
aside for reassembly.
3. 700/1000/1400 VA models: Gently pull on the white tabs located on both
sides of the battery until wiring is exposed (Figure 3). Disconnect red wire (+)
(figure 4) and the black wire (-) (figure 5).
2200 VA model: Pull apart the Battery harness connector (Figure 6 & 7).
Remove batteries.
4. Unpack new batteries taking care not to destroy the packing.
5. Slide new batteries into the cavity, noting the white pull-tabs are facing
outward.
6. For 700/1000/1400 VA models: Connect the battery wires; first black to black,
then red to red. For 2200 VA models: Connect the battery harness
connector. Push batteries back into cavity.
NOTE: There will be a small spark when connecting the Red to Red
connectors on 700-1400 VA models, and on the 2200 VA model when
connecting the battery harness connector. This is normal and will not harm
you or the UPS.
7. Replace the Battery retaining plate by inserting the (4) screws into their
associated holes. Tighten the (4) screws to secure the battery retaining plate
in place.
8. Replace the Battery door by inserting the four (4) screws into their associated
holes. Tighten the four (4) screws to secure the battery door in place.
9. Dispose of batteries in accordance with your local laws and regulations.
DISCONTINUED
PRODUCT