Filter
Top Products
14. Locate the BOTTOM COVER (13). Remove the ACCESS
DOOR (N) and set it aside. Drop the POLAR CABLE (O)
through the opening. Install the BOTTOM COVER to the
HANDRAIL/BRIDGE ASSEMBLY (5) using twelve
SCREWS (7). Connect the POLAR CABLE to the con-
nector located under the CONSOLE BRIDGE. Tighten the
SCREWS securely.
NOTE: BE SURE THE BOTTOM COVER FULLY SEATS
INTO THE ERGO CROSSBAR GASKETS.
NOTE: BE SURE THE BOTTOM COVER IS FULLY
SEATED TO THE TOP COVER AND ARMS.
15. Attach the FRONT NECK SHROUD (14) using two
SCREWS (7). Tighten the SCREWS securely.
16. Position the ACTIVITY ZONE ASSEMBLY (15) near
the ERGO CROSSBAR of the HANDRAIL/BRIDGE
ASSEMBLY (5) as shown. Connect the ACTIVITY
ZONE FLAT RIBBON CABLE (P) and EMERGENCY
STOP CABLE (Q). Place the ACTIVITY ZONE ASSEM-
BLY over the TOP and BOTTOM COVERS (10 & 13) and
secure using two SCREWS (33) through the access door in
the BOTTOM COVER. Tighten the SCREWS until the ACTIVI-
TY ZONE ASSEMBLY is tight against the TOP and BOTTOM
COVERS. Do not overtighten the SCREWS.
NOTE: BE SURE TO ROUTE THE FLAT RIBBON CABLE (R)
OVER THE ERGO CROSSBAR.
NOTE: BE SURE TO ROUTE THE EMERGENCY STOP
CABLE (R) THROUGH THE NOTCH IN THE BOTTOM
COVER.
17. Replace the BOTTOM COVER ACCESS DOOR (N).
18. Position the CONSOLE (16) near the CONSOLE
BRACKET (6). Connect all cables. Secure the
CONSOLE to the CONSOLE BRACKET using
four SCREWS (17). Tighten the SCREWS
securely. Do not overtighten the SCREWS.
NOTE: BE CAREFUL NOT TO DAMAGE THE
CABLES WHEN INSTALLING THE CON-
SOLE.
19. If not already in place, install the LCD
ACCESS COVER (18) to the REAR CON-
SOLE COVER (19).
Install the REAR CONSOLE COVER to the
CONSOLE BRACKET (6) using two
SCREWS (7). Tighten the SCREWS
securely. Do not overtighten the
SCREWS.
20. Remove the protective backing from the
four HOOK AND LOOP FASTENERS (S)
located on the back of the LEFT SIDE
EXTRUSION (23). Align the LEFT SIDE
EXTRUSION with the channel in the LEFT SIDERAIL
(T). Tilt and engage the LEFT SIDE EXTRUSION to the
LEFT SIDERAIL. Press firmly on the underside of the
LEFT SIDE EXTRUSION to secure the HOOK AND
LOOP FASTENERS to the frame. (See next page)
7 13
5
10
O
7
N
16
18
19
7
17
6
14
7
15
Q
33
N
P
5
R