Filter
Top Products
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
30
SEC
Insert window with bent edge at top and
pointing away from the wall.
AHE
ADZ
ADZ
AIS
AIS
SEC
6.1
Remove plastic sheeting from Window (AHE) and slide Window into slot on the Window Wall Panel. Attach a
Window Latch (AIS) above each corner of the Window as shown. When tightening the 1/4” x 5/8” Phillips Pan-Head
Screws (ADZ), ensure the Window Latches slide freely. Do not overtighten. Insert the #10 x 3/8” Phillips Pan-Head
Screw (ADY) into the hole in the Window.
AISX
ADZ (x4)
ADY (x1)
Note: Insert window with bent edge at top
and pointing away from the wall.
Note: Place Screw (ADY) in this hole to keep window from
sliding up too far. Insert until flush with the window.
!
!
S
SEC
6