Filter
Top Products
- 10 -
16. Select 'CD-ROM drive' and click 'Next', Select 'The Updated driver (Recommended)'
NEC PCI To USB Enhanced Host Controller click 'Next'.
17. When the wizard indicates that it found a driver for the device click 'Next'.
Then click 'Finish' to exit the wizard.
18. The Hardware wizard will display that it found 'NEC Firewarden OHCI Compliant IEEE
1394 Host Controller', click 'Next'
19. Select 'Search for the best driver for your device (Recommended)'. Click 'Next'.
20. Select 'CD-ROM drive' and click 'Next'. Select 'The Updated driver (Recommended)'.
NEC Firewarden OHCI Compliant IEEE 1394 Host Controller', click 'Next'. And click
'Next' to continue.
21. If display 'Insert Disk' (please insert the disk labeled windows 98 second Edition
CD-ROM) and click OK, Then click 'Finish' to exit the wizard.
22. The Hardware Wizard will display that it found a 'PCI Raid Controller', click 'Next'.
23. Select 'Search for the best driver for your device [Recommended]' and click 'Next',
and insert CD driver into CD-ROM drive.
24. Make sure the 'CD-ROM drive' checkbox is checked. Click 'Next'. And click 'Next' to
continue.
25. System will go through the enumeration process and install the driver.
At the end of the process, click ' Finish' to complete the installation.
Reboot the system if your Windows 98SE drive is connected on the
SiI 3112 Controller.
4.7. Windows ME installation
1. Power off the system. Insert Combo Card into an available PCI slot. Power up the
system.
2. During the system boot up, the Hardware Wizard will display that it found 'PCI standard
PCI-to-PCI bridge', select 'Automatic search for a better driver (Recommended)',
click 'Next' and then click 'Finish' to exit the wizard.
3. The Hardware wizard will display that it found 'NEC Firewarden OHCI Compliant IEEE
1394 Host Controller'. Select 'Automatic search for a better driver
(Recommended)'. Click 'Next' and then click 'Finish' to exit the wizard.
4. The Hardware wizard will display that it found 'PCI Universal Serial Bus'. Select
'Automatic search for a better driver (Recommended)', insert CD driver into
CD-ROM drive, click 'Next', and then click 'Finish' to exit the wizard.
5. The Hardware Wizard will display that it found a 'PCI RAID Controller', Select
'Automatic search for a better driver (Recommended)'. Click 'Next'.
6. System will go through the enumeration process and install the driver.
At the end of the process, click 'Finish' to complete the installation.