Filter
Top Products
- 6 -
and click “Next”.
8. Select “Search for the best driver for your device(Recommended)”. Click
“Next”.
9. Select “Floppy disk drives” and uncheck the other boxes and click “Next”, Select
“The Updated driver (Recommended)” NEC USB Open Host Controller, and click
“Next”, then click “Next” to continue.
10. If display “Insert Disk” (please insert the disk labeled windows 98 second Edition
CD-ROM) and click OK, Then click “Finish” to exit the wizard, and Remove your
Windows 98 second Edition CD-ROM.
11. The Hardware wizard will display that it found “PCI Universal serial Bus”, and click
“Next”.
12. Select “Search for the best driver for your device (Recommended)”. Click
“Next”,
13. Make sure the “ Specify a location: “ checkbox is only checked, and insert the “Driver
CD” in your CD-ROM/DVD drive, then click “Browse”.
14. Points specify a location, example E:\USB2.0 Host\NEC\Win98_me.
Click “OK”, and click “Next”. (If your CD-ROM/DVD drives is E:)
15. When the wizard indicates that it found a driver for the device, click “Next”. Then click
“Finish” to exit the wizard.
16. The Hardware wizard will display that it found “PCI Ethernet Controller”, click “Next”,
select “Search for the best driver for your device (Recommended)”, click “Next”, Check
“Specify a location”, uncheck the other boxes,
17. Insert the “Driver CD” in your CD-ROM/DVD drive type in E:\ (If your
CD-ROM/DVD is E:\) and click “Browse”.
18. Points specify a location, example E:\10_100_1000NIC\RTL8169 \WIN98se, and
click “OK” then “Next”.
19. Click “Next” if display “Insert Disk” (please remove the Driver CD from your
CD-ROM/DVD and insert the disk labeled windows 98 second Edition CD-ROM) and
click “OK”, then click “Finish”.
20. When install driver finish, please remove windows 98 Second Edition CD-ROM, and
click “YES” to restart your computer.
2.5. Windows ME installation
1. Power off the system. Insert Combo Card into an available PCI slot. Power up the
system.
2. The Hardware wizard will display that it found “PCI Universal Serial Bus”, Select
“Specify the location of the driver (Advanced)”, and insert the “Driver CD” in your
CD-ROM/DVD drive, and click “Next”.