Filter
Top Products
ADSL Ethernet Modem
5
Connecting the ADSL Ethernet
Modem to Your PC
1. Attach one end of a standard network cable (included) to your computer’s
network adapter and the other to the ADSL Ethernet Modem’s LAN port.
2. Connect the standard phone cable (included) from the ADSL outlet to the
Line port on the ADSL Ethernet Modem.
3. Plug in the Modem's AC power adapter to the Power port on the back
of the Modem. Plug the other end of the Power adapter into an electrical
outlet. The Power LED will light up.
The Hardware Installation is complete. If you are configuring the ADSL
Ethernet Modem using your network connection, refer to the Installing
the TCP/IP Protocol section in the Appendix.
Power Green. The Power LED lights up when the Modem is pow-
ered on.
Alert Red. The Alert LED is off during normal Modem operation.
When an alarm or error occurs, this light will be on. The
LED will blink when firmware is being downloaded or self-
testing is in progress.
LAN Activity Green. Lights when the LAN connection has an activity.
LAN Link Green. The LAN Link lights up when a successful Ethernet
connection is made through the corresponding port. If this
LED is not lighting up, then an Ethernet connection has not
been established.
ADSL Link Green. The ADSL Link is continuously lit up when the
Modem is successfully connected to an ADSL line. If the
Link LED is blinking, the unit is attempting a connection to
an ADSL line.
ADSL Tx Green. The ADSL Tx LED blinks when the Router is active-
ly sending or receiving data over that port.
The ADSL Ethernet Modem’s Front Panel
Instant Broadband
TM
Series
4