Filter
Top Products
22
Chapter 5: Configuring the Dual-Band Wireless A+G Broadband Router
The Wireless Tab - Wireless MAC Filter
Dual-Band Wireless A+G Broadband Router
The Wireless Tab - Wireless MAC Filter
Wireless access can be filtered by using the MAC addresses of the wireless devices transmitting within your
network’s radius.
Wireless MAC Filter
Access Restrictions
To filter wireless users by MAC Address, either permitting or blocking access, click Enabled. If you do not wish to
filter users by MAC Address, select Disabled.
Prevent PCs listed below from accessing the wireless network. Clicking this radio button will block wireless
access by MAC Address.
Permit PCs listed below to access the wireless network. Clicking this radio button will allow wireless access
by MAC Address.
Wireless Client List
Wireless Client List. Click the Wireless Client MAC List button to display a list of network users by MAC
Address.From the To Sort by drop-down menu, you can sort the table by Client Name, Interface, IP Address, MAC
Address, or Status. If you want to add any of the wireless clients to the Wireless MAC Filter List, then click the
Save to Wireless Client List checkbox and then click the Save Settings button. Click the Cancel Changes
button to cancel your changes. To view the most up-to-date information, click the Refresh button. To exit this
screen, click the Close button.
List users, by MAC Address, whose wireless access you want to control.
Change these settings as described here and click the Save Settings button to apply your changes or Cancel
Changes to cancel your changes. Help information is shown on the right-hand side of the screen. For additional
information, click More.
Figure 5-13: Wireless Tab - Wireless MAC Filter
Figure 5-14: Wireless Client List