Filter
Top Products
CLONING MODES AND SETTINGS
20 Logicube Omniclone Xi ™ User’s Manual
Optional Preference Settings
In addition the different cloning modes, there are
preference settings that can be used to adjust the
behavior of the cloning operation. Each of these
preference settings is accessible through the
Settings menu, which can viewed at any time from
anywhere in the menu system by pressing the Set
button.
NOTE: Not all preference settings are available in
every cloning mode.
Verify
The Verify preference allows you to choose whether
the Logicube Omniclone Xi™ verifies the data
copied to the Target drive. Verify also scans the
Target drives for bad or weak sectors. With Verify
activated, data written to the Target is read back
sector by sector and compared against the original
data on the Master. If a bad sector of data is
detected, the cloning process is aborted.
Verify Settings
• No Verify (Default) - No data verification is
performed.
• 1% Verify - Only the first 1% of the data sectors
are verified. This is faster but less thorough than
using the All setting.
• 100% Verify - Every data sector on the Target
drive to which data has been written is checked.
NOTE: Logicube strongly recommends against
using a hard drive that has been shown to have bad
sectors as new defects are likely to develop.