Filter
Top Products
4-8 BIOS Features
Ver. 2.0 Copyright © 2002 by LSI Logic Corporation. All rights reserved.
4.8.2 Identifying the Fibre Channel Disks
The probe-scsi-all command is used to identify the Fibre Channel
devices on your Fusion-MPT adapter.
To show all disks available from the openboot prompt, use the probe-
scsi-all command. Note that this command is used regardless of
whether the disks are Fibre Channel or SCSI. All disks available on all
Fusion-MPT devices are displayed.
The following example shows the kind of information that is displayed
when you enter this command.
ok probe-scsi-all
/pci@8,600000/SUNW,qlc@4
LiD HA LUN ---Port WWN--- ----Disk description----
1 1 0 2100002037e4d65b SEAGATE ST318304FSUN18G 0726
/pci@8,700000/IntraServer-Ultra160,scsi@3,1
/pci@8,700000/IntraServer-Ultra160,scsi@3
Target 0
Unit 0 Disk IBM DDRS-34560D DC1B
/pci@8,700000/IntraServer,fc@2
MPT Version 1.00, Firmware Version 1.02.00
Target 0
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 2100002037109d76 Port ID d9
Target 1
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 210000203710565a Port ID 17
Target 2
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 2100002037105212 Port ID 1
Target 3
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 2100002037103da8 Port ID 26
Target 4
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 210000203710324a Port ID 73
/pci@8,700000/scsi@6