Filter
Top Products
Connecting Internal SCSI Devices 1-5
1.2 Connecting Internal SCSI Devices
Step 1. If you are connecting an internal SCSI device, plug the 50-pin
connector cable on one end of the internal SCSI ribbon cable
into the connector J2 (see Figure 1.3). The ribbon cable
included in your SYM20810 host adapter kit is keyed to assure
that it can be easily connected.
Step 2. Plug the 50-pin connector on the other end of the ribbon cable
into the SCSI connector on your internal SCSI device.
Step 3. To attach more than one internal device, use a SCSI ribbon
cable with the required number of 50-pin connectors attached
along its length. Plug the cable connectors into the internal
SCSI device connectors, as illustrated in Figure 1.3.
Step 4. Terminate the SCSI bus as described in the Section 1.2.3,
“SCSI Bus Termination,” page 1-9.
Step 5. Make any required power connections to your internal SCSI
device(s).