Filter
Top Products
Detailed Installation Procedure 1-5
Rev. 2.0 Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Figure 1.1 Hardware Connections for the LSI Logic Host Adapter
Step 7. Carefully insert edge connector J1 (see Figure 1.1) of the host
adapter into the PCI slot.
Make sure the edge connector is properly aligned before
pressing the board into place as shown in Figure 1.2. The
bracket around connector J2 should fit where you removed the
blank panel.
SFF Optical
Connector
Fibre Channel
Link Activity/
Link Fault LED
PCI Bus Edge Connector J1
LSI Logic Host Adapter