Filter
Top Products
7
Use this Product Safely
Proper Power Supply
This product is designed to operate with a 12
Volt DC, negative ground battery system.
Do not operate screen in manner other than
described in this manual. Doing so may damage
it and may void your warranty.
WARNING: FOR REAR SEAT VIEWING ONLY!
Do not install on dashboard or anywhere else
that would permit monitor to be viewed by the
driver. Screen must never be used in any man-
ner that will distract driver or interfere with the
driver's safe operation of the motor vehicle.
Battery:
Be careful not to run down the car battery while
using the monitor while the car is stopped.
Modify:
Do not disassemble or modify the monitor. Doing
so may damage it and voids your warranty.
Moisture:
Keep drinks and all liquids away from monitor.
Water may damage the internal circuitry.
Heat/Cold Exposure:
Do not let the monitor become hot. If tempera-
ture in the car is high or the monitor bas been
exposed to direct sunlight and is hot, lower the
temperature before using it.
In extreme cold temperatures. the movement of
the picture may become slow and the picture
may be dark, but this is not a malfunction. The
set will work once the temperature increases.
Cleaning
Use a soft cloth with some purified water to
clean the screen. Do not use any cleaner or
chemical to clean the screen. Usually, a dry
cloth will do.
Warning
Be careful not to drop or apply undue pressure to
the front panel of monitor. If the screen cracks
due to misuse, the warranty will be voided!
Wiring
Power Harness Wiring:
The 3 wire harness provides battery and igni-
tion 12 volts as well as a chassis ground.
Route the power harness to the point in the
vehicle that you will make the connections.
Red Wire: The red wire in the harness should
be connected to a +12 volt power wire that
is turned On and Off by the position of the
ignition key.
Yellow Wire: The yellow wire in the harness
should be connected to a constant +12 volt
wire that is NOT turned On and Off by the
position of the ignition key.
Black Wire: The black wire in the harness
should be connected to the chassis of the
vehicle using a ring terminal and self tap-
ping screw or bolt and nut.
Door Trigger for Dome Light:
Connect the white wire on the to the common
(-) door pin trigger wire that normally acti-
vates the factory dome light when any door
is opened. This wire can usually be located at
the dome light harness in the vehicle ceiling.
Other connection points could be as follows:
• At the vehicle door pin (diodes may be
required to tie all door pin wires to make a
common wire)
• At a light in the door or under the dash-
board that is on when any door is opened.
MV750-UM.qxp 6/15/07 11:44 AM Page 7