Filter
Top Products
4040
4040
40
3.4.13.4.1
3.4.13.4.1
3.4.1
CPU ConfigurationCPU Configuration
CPU ConfigurationCPU Configuration
CPU Configuration
BIOS SETUP UTILITY
CPU Configuration
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
v02.54(C)Copyright 1985-2005, American Megatrends, Inc.
Advanced
Boot Failure Guard
Spread Spectrum
[Enabled]
[Auto]
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
Ratio Status Unlocked (Min:06, Max:08)
Ratio Actual Value 8
Select the over clock
mode.
CPU Frequency (MHz)
PCIE Frequency (MHz)
Overclock Mode
[266]
[100]
[Auto]
Enhanced Halt State
Intel Virtualization tech.
CPU Thermal Throttling
No-Excute Memory Protection
Hyper Threading Technology
Intel(R) SpeedStep(tm) tech.
[Disabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[Auto]
Overclock Mode
Use this to select Overclock Mode. Configuration options: [Auto], [Manual],
[I.O.T.] and [Optimized]. The default value is [Auto]. If you select [Manual],
Untied Overclocking function is enabled. Please refer to page 36 for the
details of Untied Overclocking Technology. If you select [I.O.T.] (Intelligent
Overclocking Technology), you are allowed to adjust the CPU frequency
and PCIE frequency in the following two items. Therefore, the system will
automatically enable the overclocking function when your CPU is heavy
loaded.
BIOS SETUP UTILITY
Main Smart
H/WMonitor Boot Security Exit
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
v02.54(C)Copyright 1985-2005, American Megatrends, Inc.
Advanced
Advanced Settings
WARNING: Setting wrong values in below sections
may cause system to malfunction.
CPU Configuration
Chipset Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
ACPI Configuration
Options for CPU
3.43.4
3.43.4
3.4
Advanced ScreenAdvanced Screen
Advanced ScreenAdvanced Screen
Advanced Screen
In this section, you may set the configurations for the following items: CPU Configuration,
Chipset Configuration, ACPI Configuration, IDE Configuration, PCIPnP Configuration,
Floppy Configuration, SuperIO Configuration, and USB Configuration.
Setting wrong values in this section may cause
the system to malfunction.