Filter
Top Products
5
CAUTION:
• Do not apply impact to the light, which may cause
damage or shorted service time to it.
To turn on the lamp, press the “I”(ON) side of the lamp
switch. Press the “O”(OFF) side to turn it off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
• Do not use thinner or gasoline to clean the lamp.
Such solvents may damage it.
• After operation, always turn off the light by pressing
the “O (OFF)” side.
Hook (Optional accessory)
The tool may be hung using the hook. Hang tool on a
pipe vice or other suitable, stable structure.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the blade
CAUTION:
• Oil on the blade can cause the blade to slip or come
off unexpectedly. Wipe off all excess oil with a cloth
before installing the blade.
• Use caution when handling the blade so that you
are not cut by the sharp edge of the blade teeth.
Turn the blade tightening lever clockwise until it hits
against the protrusion on the frame.
Match the direction of the arrow on the blade to that of
the arrow on the wheels.
Position the blade around the wheels and insert the other
side of the blade within the upper holder and lower holder
until the blade back contacts the bottom of the upper
holder and lower holder.
Start and stop the tool two or three times to make sure
that the blade runs properly on the wheels.
CAUTION:
• While making sure that the blade runs on the
wheels properly, keep your body away from the
blade area.
To remove the blade, follow the installation procedure in
reverse.
CAUTION:
• When turning the blade tightening lever clockwise
to release the tension on the blade, point the tool
downward because the blade may come off
unexpectedly.
Adjusting the protrusion of stopper plate
Protrusion of the stopper plate to the blade can be
adjusted.
1. Hook
1. Tighten
2. Loosen
3. Protrusion
4. Lever
1
006190
12
4
3
006191
1. Blade
2. Bearing
3. Upper holder
4. Lower holder
1. Upper holder
2. Lower holder
3. Wheel
4. Press
1. Screw
2. Stopper plate
3. Blade
1
2
3
4
006192
1
2
3
4
006193
1
3
2
A
B
006194