Filter
Top Products
23
ADDITIONAL INFORMATION
ENGLISH
7
Optical characteristics
Panel 0.85inch 16:9
1,280 x 720 pixels
Digital Micromirror Device
TM
Lamp Super High Pressure 150W
Lens f: 26.5 to 30.7 / F: 3.0
Projection size 40 to 250 inches
Light output 700 ANSI LUMEN typical
7
INPUT/OUTPUT
VIDEO IN RCA x 1
NTSC-3.58/PAL-4.43/SECAM
Composite video 1.0V
p-p/75 Ohm
S-VIDEO IN S-Connector x 1
NTSC-3.58/PAL-4.43/SECAM
S-Video
COMPONENT IN RCA x 3
Y, C
B/PB, CR/PR
RGB/HD IN D-sub M 15 pin x 1
Analog RGB
HD:1080i, 720p, 480p
REMOTE
CONTROLLER IN Mini jack type x 1
REMOTE
CONTROLLER OUT Mini jack type x 1
AC IN 3 Prong Grounding Type
TRIG.1 OUT,
TRIG.2 OUT Mini Jack x 2
Output: DC12V or 0V
RS232C RS232C receptacle plug x 1
AUX. IN IEEE1394 AV receptacle plug x 1
COAXIAL Digital
AUDIO OUTPUT COAXIAL audio data output x 1
OPTICAL Digital
AUDIO OUT OPTICAL audio data output x 1
7
GENERAL
Power requirement
AC 100-120V / 220-240V, 50/60 Hz
Power consumption <250 W
Standby consumption
<3.3 W
Chassis isolation Class-1
Safety UL6500
CSA E60065
EN60950
J60065
IEC60950
EMC FCC Part-15 Class-B
EN55022 Class-B
EN55024
EN61000-3-2,3
Dimensions 235(W) x 322(D) x 96(H)mm
Net weight 12 kg
Operating Temperature 5 to 35 °C
Operating humidity 30 to 85%
Storage Temperature –20 to 60 °C
Storage humidity 30 to 85%
Accessories • Lens cap x 1
• Remote controller x 1
• Batteries x 2
• AC power code (only for 125V) x 1
• User Guide x 1
• Control Adapter cable
(Mini jack to RCA) x 1
• Ferrite cores x 2
Specifications may be subjected to change without any prior notice.
SPECIFICATIONS
NO SIGNAL
REPLACE LAMP!
OUT OF RANGE
No input signal.
The lamp has reached the end of its life.
Improper signal feed to the projector.
Properly connect the cables.
Replace the lamp and reset lamp life.
Adjust resolution, V(Hz) : refresh rate of the
equipment, referring to the Timing Chart.
MeaningMessage Remedy
Use the list below to check the message displayed on the screen.
ON SCREEN MESSAGE