Filter
Top Products
MMI Product Documentation
Unipro 3.5 Process Control 1 Aug. 1997
Restarting a Program From HOLD
1. Press [PROG/AUTO/MAN] UNTIL the
instrument is in Programmer mode as indicated
by the Prog LED. The LED should be flashing
signifying a program is in HOLD.
OR
Press [SHIFT] +[LEFT ARROW].
2. Do not alter the program number, otherwise, the
program will start from the first step and not
where it had left off.
3. Press [ENTER] and the program will continue
executing with the step where the HOLD was
initiated.
To Enter Program Editor*
1. Press Shift/Setpt
2. Select the program to be edited using the "arrow
keys"(Edit / 0001)
3. Press Enter
* Note that the unit will allow editing of a program that
might be running. This editing will not affect the
currently-running copy of this program until the program is
actually restarted, either manually or by a program jump.
To Edit Program Steps
1. Use the [LEFT ARROW] and [RIGHT ARROW]
keys to select digits to be changed (either the
OPCODE or the data)
2. Use the [UP ARROW] and [DOWN ARROW]
keys to change the selected digit
3. Press [ENTER] to move forward to the next step, or
4. Press [Shift] to move backward to the previous step
5. If at any point the program does not advance or
back up, and the entire SET display starts flashing,