Filter
Top Products
PRE-OPERATING INSTRUCTIONS
06-0045
460
VOLTS
DANGER
NEVER ENTER ANY PART OF THE BALER UNLESS THE DISCONNECT
SWITCH HAS BEEN TURNED OFF AND PADLOCKED. Before starting the
baler, be sure no one is inside. Be certain that everyone is clear of all points of
operation and pinch point areas before starting. See Lock-Out & Ta g - O u t
instructions in the Maintenance section.
THE EMPLOYER SHOULD ALLOW ONLY
AUTHORIZED AND TRAINED PERSONNEL TO
OPERATE THIS BALER. This baler is equipped with
a key operated locking system. The key(s) should be
in the possession of only authorized personnel. Turn
off and remove key after use.
Pay close attention to the RED WARNING LIGHT on the control panel. If the light
is illuminated when the feed gate is raised, there is a malfunction of the
magnetic interlock system. IN THIS EVENT, DISCONTINUE USE OF THE BALER
AND LOCK-OUT & TAG-OUT THE BALER PER THE INSTRUCTIONS IN THE
MAINTENANCE SECTION, PAGE 2-1. Perform necessary repairs before
continuing operation of the baler.
O N LY AUTHORIZED PERSONNEL
SHOULD BE ALLOWED INSIDE THE
PA N E L B O X . The panel box contains
high voltage components. See Lock-Out
& Tag-Out instructions in the
Maintenance section.
BE CERTAIN TURNBUCKLE AND LATCH IS FULLY LOCKED IN PLACE ON BALE
CHAMBER DOOR BEFORE STARTING BALER.
STAND CLEAR WHILE
BALER IS IN OPERATION.
WARNING: DO NOT OPERATE BALER UNTIL OPERATING INSTRUCTIONS ARE
THOROUGHLY UNDERSTOOD.
1-3
Federal regulation prohibits operation by persons under 18 years of age.
1 OPERATION
400