Filter
Top Products
9-32
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
HDD Damper Ass’y
Make sure the product with black
sheet on the yellow sponge.
HDD Set Insert after removing the Release Paper of the two-sided tape.
Fold the FPC from the board edge.
HDD Ass’y
Remove the Release Paper on
the back, close and attach it.
Attach it to HDD closely not to loosen.
Push and bend
Longer Direction
(15)
(10)
HDD Thermal Plate
1 2
1 2
1 2
0 1
1 2
1 2
Attach the HDD Cushion (Yelllow)
Attach the HDD Cushion (Yelllow)
Attach the HDD Cushion
(Black)
Attach the HDD
Thermal Plate
HDD Cushion (Black)
15 1
* Notes:
1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2
Only the metal plate
attached on this side
Displace the edge by
10 mm and fold back.
Prepare the metal plate bend.
Do not bend it at a sharp
angle to put natural R.
To the level of attaching
closely in this range
When attaching HDD Cushion (Yellow) and HDD Cushion (Black),
set the bending part of the metal plate up.
Metal Plate
Remove the Release Paper.