Filter
Top Products
MicroTrack 24/96 User Guide
13
English
Playback
Now that a file has been recorded, you can play it back to check the recording.
1. Connect the outputs of the MicroTrack 24/96 so you can hear the playback. You can use any combination of the following:
< Plug a pair of headphones into the 1/8” jack on the MicroTrack 24/96.
< Connect the RCA outputs to an amplifier or mixer.
2. Use the [MENU] button and [NAV] wheel to navigate to the “Files” menu.
3. Use the [NAV] buttons to select a file to play. Press in on the [NAV] wheel to begin playback of the current file.
The triangle in the upper-left corner of the screen shows that the MicroTrack 24/96
is playing a file. The file being played is “file001.mp3.” The numbers in the lower-left
corner show that this is file 1 of 142 files on the media. The lower-right corner shows
the current play time and the current file length.
4. While an audio file is playing, you can:
< adjust the volume using the [VOLUME] button.
< pause playback by pressing in on the [NAV] wheel. Press in again to resume playback.
< fast-forward through the file by holding up the [NAV] wheel.
< rewind the file by holding down the [NAV] wheel. If you are within the first three seconds of a file, pressing down will skip back
to the previous file.
< skip ahead to the next file by pressing in and up on the [NAV] wheel.
< return to the beginning of the file by pressing in and down on the [NAV] wheel.
< delete the file by pressing the [DEL] button.
< immediately begin recording a new file by pressing the [REC] Button.
< loop playback of the file using the procedure explained below.
Loop Playback
The MicroTrack 24/96 will allow you to loop a section of an audio file. This can be useful when practicing parts or studying dictation. The
method for looping a file requires setting a start and end point, and is accomplished as follows:
1. To engage Loop Playback, press and hold the [MENU] button for over 2 seconds while the file is playing.
2. Press the [MENU] button once when you reach the start point of the loop.
3. Press the [MENU] button a second time when you reach the end point of your loop. The section will begin to loop immediately.
4. Pressing the [MENU] button a third time will exit loop mode.
While using the Loop Playback mode, you will not be able to skip to other files using the up and down action of the [NAV] wheel. You
will only be able to fast-forward or rewind the current file by holding the [NAV] wheel in your desired direction.
4 - Operating Instructions