Maxtor 98196H8 Computer Drive User Manual


 
INTERFACE COMMANDS
7 – 9
Default Power-on ConditionDefault Power-on Condition
Default Power-on ConditionDefault Power-on Condition
Default Power-on Condition
The drive’s default power on condition is the ACTIVE MODE.
Upon receiving a Power Mode command, except the SLEEP MODE command, the drive sets BSY and
performs the requested power operation. Once the requested Power Mode change has begun, the drive
resets BSY and generates an interrupt - without waiting for the drive to spin up or spin down. Upon
receiving a SLEEP MODE command the drive is spun down, and when it is stopped, the drive resets BSY
and generates an interrupt.
When enabling the Automatic Power Down sequence, the value placed in the Sector Count register is
multiplied by five seconds to obtain the Time-out Interval value. If no drive commands are received from
the host within the Time-out Interval, the drive automatically enters the STANDBY mode. The minimum
value is 5 seconds.
While the drive is in STANDBY MODE, any commands received from the host are accepted and executed
as they would in normal operation, except that the spin motor is started if required to execute a disk
command. Under these conditions, the drive will set BSY when command processing would normally begin
and will leave BSY set until the drive comes up to speed and the disk command can be executed. Disk
commands issued while the drive is in STANDBY MODE, restarts the Time-out Interval after completing
the command. A reset must be issued before attempting to issue any commands while the drive in
SLEEP MODE.